Evco EC7102 Manual do Utilizador descarregar pdf (Página 4)

2 '01

PARAMETERS CONFIGURATION

The configuration parameters programming can be done during the status "Status 0" only, if there is not a corrupted memory data alarm.

Programming procedure for the parameters "t11", "t20" and "t24"

A) Keep pushed and at the same time for 4 seconds at least: on the display appear "t 0".

B) Push or to select the parameter to modify.

C) Push and release the most important side of the display flashes;

operate with or within 4 seconds since the first pressure on to modify its value.

D) Push and release for a second time during the flashing of the most important side of the display: since now the

least important side of the display flashes;

operate with or within 4 seconds since the second pressure on to modify its value.

E) After the modify push and release for a third time or wait 4 seconds without operate on the keys (time-out exit).

Programming procedure for all other parameters

Follow the procedure described in A and B and

F) Push and release to display the actual value of the selected parameter.

G) Push or within 4 seconds since the pressure on to modify its value.

H) After the modify push and release or wait 4 seconds without operate on the keys (time-out exit).

How to leave the programming procedure

Keep pushed and at the same time for 4 seconds at least or wait 50 seconds without operate

on the keys (time-out exit).

EXAMPLE OF FUNCTIONING

ALARMS

"E:2" flashing on the display and buzzer beeping intermittent (corrupted memory data alarm) indicate the failure of the memorised configuration data:

try to switch the power supply off and then switch it on; if to the restart the alarm condition does not disappear it is necessary to change the instrument

(all the outputs are deactivated).

1 2 3 4 5 6

Comentários a estes Manuais

Sem comentários

Evco EC7102 Manual do Utilizador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Evco EC7102